DIN Rail Accessories

DIN Rail

DIN rail, sometimes called Top-Hat Rail, is a standardized 35mm wide metal rail with hat-shaped cross section. It is widely used for mounting components, assemblies, and industrial control equipment inside equipment racks and enclosures. Rails are slotted for easy mounting. Sold in lengths of 39".

DIN Rail Mounting Clip for SNAPTRACK

Clip allows SNAPTRACK (type 121-0003 and type 121-0010) to mount to symmetrical DIN rail, asymmetrical DIN rail, and A series rail. Recommended use is two clips evenly spaced every four inches.

Screw-Down Clip

This DIN clip has a center hole which accommodates the threads of a 4-40 flat-head machine screw being passed up from the bottom. Alternatively, two self tapping screws can be inserted from the top using a hole spacing of .709 inches. Screw hardware not included with clip.

Snap-Fit Mounting Clip

Design your PCB with the hole pattern shown and this clip snaps into place. Quick assembly promotes lower production costs.

Isolated Mounting Clip

A simple and practical way to mount devices to DIN Rail. A single screw passes though a hole in the component to be mounted and into the center hole of the clip. Includes a self-tapping screw and washer for attaching components.

Universal Screw-Down Mounting Clip

This DIN rail clip is designed to mount to both symmetrical (Top-Hat) and asymmetrical (G Type) DIN rail. The flat mounting surface and the three non-threaded mounting holes make this clip versatile for mounting a variety of devices on to DIN rail. The holes are sized to accept a #6 or M3 metric coarse threaded machine screws (not included). When mounting a standard 0.0625" circuit board a 0.375" screw length is a good choice.

End-Stop

End-Stops prevent components from moving laterally on the DIN rail. Typical use is one End-Stop on each end of the rail placed up snuggly against the components.